For the roughing pass we will leave an allowance of 0. The next cut will be a pocket taking the whole surface down in 2 steps, a rough and finishing pass. Make sure to set the tool path depth and machining order starting at one and increment by at least one. If you had a nice flat piece of material you can make it easier and just start at the work surface.įor the cut I select Insidepocketand selected the outer most path, shown in red. The first cutting step will be the basic surfacing of the wood to make sure the top is nice and flush. Just select Zero, Point, and Click where you want the new Zero. The tool will be starting off to the left of the actual piece of wood touching the bed so the first step is to move the zero point over about half an inch, to approximate where the tool will start. This file has all the part paths on it but not the depth of cut so we will work though this on step at a time. The tool paths start with importing the DXF file in mm. This will allow me to easily surface the uneven wood and not have to estimate where the origin should be. I will use the bed as the start position and tell ESTLCAM the work surface is slightly higher than measured on the thickest part of the wood. So I can show some different techniques in this walk though I am using piece of Brazilian Ipe that has an uneven top surface, so no reliable Z origin. The following manual paths took 18 minutes to cut and look fantastic! The automatically generated STL paths took 50 minutes to cut and did not pick up the small 4mm hole. Ecco i titoli più venduti sul playstation store a luglio You should have a firm grasp on the basics before trying this. This is an intermediate walk through on 2.

Estlcam 11